The layer 2 switch must not use the default VLAN for management traffic.

Severity	Group ID	Group Title	Version	Rule ID	Date	STIG Version
medium	V-206669	SRG-NET-000512	SRG-NET-000512-L2S-000010	SV-206669r385561_rule	2025-03-05	3

Description
Switches use the default VLAN (i.e., VLAN 1) for in-band management and to communicate with directly connected switches using Spanning-Tree Protocol (STP), Dynamic Trunking Protocol (DTP), VLAN Trunking Protocol (VTP), and Port Aggregation Protocol (PAgP)—all untagged traffic. As a consequence, the default VLAN may unwisely span the entire network if not appropriately pruned. If its scope is large enough, the risk of compromise can increase significantly.

Description

Switches use the default VLAN (i.e., VLAN 1) for in-band management and to communicate with directly connected switches using Spanning-Tree Protocol (STP), Dynamic Trunking Protocol (DTP), VLAN Trunking Protocol (VTP), and Port Aggregation Protocol (PAgP)—all untagged traffic. As a consequence, the default VLAN may unwisely span the entire network if not appropriately pruned. If its scope is large enough, the risk of compromise can increase significantly.

ℹ️ Check
Review the switch configuration and verify that the default VLAN is not used to access the switch for management. If the default VLAN is being used to access the switch, this is a finding.

✔️ Fix
Configure the switch for management access to use a VLAN other than the default VLAN.