The Cisco switch must be configured to advertise a hop limit of at least 32 in Switch Advertisement messages for IPv6 stateless auto-configuration deployments.
Severity | Group ID | Group Title | Version | Rule ID | Date | STIG Version |
|---|---|---|---|---|---|---|
| low | V-237754 | SRG-NET-000512-RTR-000012 | CISC-RT-000236 | SV-237754r999759_rule | 2024-12-20 | 3 |
| Description |
|---|
| The Neighbor Discovery protocol allows a hop limit value to be advertised by routers in a Router Advertisement message being used by hosts instead of the standardized default value. If a very small value was configured and advertised to hosts on the LAN segment, communications would fail due to the hop limit reaching zero before the packets sent by a host reached its destination. |
| ℹ️ Check |
|---|
| Review the switch configuration to determine if the hop limit has been configured for Router Advertisement messages for all internal interfaces as shown in the example. interface Ethernet2/1 no switchport ipv6 address 2001::1:0:1/64 ipv6 nd hop-limit 32 no shutdown interface Ethernet2/2 no switchport ipv6 address 2001::1:1:1/64 ipv6 nd hop-limit 32 no shutdown If hop-limit has been configured and has not been set to at least 32, it is a finding. |
| ✔️ Fix |
|---|
| Configure the switch to advertise a hop limit of at least 32 in Router Advertisement messages as shown in the example. SW1(config)# interface e2/1 – 2 SW1(config-if-range)# ipv6 nd hop-limit 32 SW1(config-if-range)# end |