The Cisco multicast Rendezvous Point (RP) switch must be configured to filter Protocol Independent Multicast (PIM) Join messages received from the Designated Cisco switch (DR) for any undesirable multicast groups.
Severity | Group ID | Group Title | Version | Rule ID | Date | STIG Version |
|---|---|---|---|---|---|---|
| low | V-221058 | SRG-NET-000019-RTR-000014 | CISC-RT-000840 | SV-221058r622190_rule | 2024-06-06 | 3 |
| Description |
|---|
| Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast packets, over-using the available bandwidth and thereby creating a denial-of-service (DoS) condition. Hence, it is imperative that join messages are only accepted for authorized multicast groups. |
| ℹ️ Check |
|---|
| Verify that the RP is configured to filter PIM join messages for any undesirable multicast groups. In the example below, groups from 239.8.0.0/16 are not allowed. ip pim rp-address 10.2.2.2 ip pim accept-rp 10.2.2.2 FILTER_PIM_JOINS … … … ip access-list standard FILTER_PIM_JOINS deny 239.8.0.0 0.0.255.255 permit any ! If the RP is not configured to filter join messages received from the DR for any undesirable multicast groups, this is a finding. |
| ✔️ Fix |
|---|
| Configure the RP to filter PIM join messages for any undesirable multicast groups as shown in the example below: SW2(config)#ip access-list standard PIM_JOIN_FILTER SW2(config-std-nacl)#deny 239.8.0.0 0.0.255.255 SW2(config-std-nacl)#permit any SW2(config-std-nacl)#exit SW2(config)#ip pim accept-rp 10.2.2.2 PIM_JOIN_FILTER SW2(config)#end |