The Cisco PE switch providing Virtual Private LAN Services (VPLS) must be configured to have traffic storm control thresholds on CE-facing interfaces.
Severity | Group ID | Group Title | Version | Rule ID | Date | STIG Version |
|---|---|---|---|---|---|---|
| medium | V-221044 | SRG-NET-000193-RTR-000002 | CISC-RT-000700 | SV-221044r622190_rule | 2024-06-06 | 3 |
| Description |
|---|
| A traffic storm occurs when packets flood a VPLS bridge, creating excessive traffic and degrading network performance. Traffic storm control prevents VPLS bridge disruption by suppressing traffic when the number of packets reaches configured threshold levels. Traffic storm control monitors incoming traffic levels on a port and drops traffic when the number of packets reaches the configured threshold level during any one-second interval. |
| ℹ️ Check |
|---|
| Review the switch configuration to verify that storm control is enabled on CE-facing interfaces deploying VPLS as shown in the example below: interface GigabitEthernet3 no switchport no ip address service instance 10 ethernet encapsulation untagged bridge-domain 100 storm-control broadcast cir 12000000 ! ! If storm control is not enabled at a minimum for broadcast traffic, this is a finding. |
| ✔️ Fix |
|---|
| Configure storm control for each CE-facing interface as shown in the example below: SW1(config)#int g3 SW1(config-if)#service instance 10 ethernet SW1(config-if-srv)#storm-control broadcast cir 12000000 SW1(config-if-srv)#end Note: The acceptable range is 10000000 -1000000000 for a gigabit ethernet interface, and 100000000-10000000000 for a ten gigabit interface. Storm control is not supported on most FastEthernet interfaces. |