The Cisco switch must be configured to automatically audit account disabling actions.

Severity	Group ID	Group Title	Version	Rule ID	Date	STIG Version
medium	V-220573	SRG-APP-000028-NDM-000210	CISC-ND-000110	SV-220573r960783_rule	2025-02-20	3

Description
Account management, as a whole, ensures access to the network device is being controlled in a secure manner by granting access to only authorized personnel. Auditing account disabling actions will support account management procedures. When device management accounts are disabled, user or service accessibility may be affected. Auditing also ensures authorized active accounts remain enabled and available for use when required.

Description

Account management, as a whole, ensures access to the network device is being controlled in a secure manner by granting access to only authorized personnel. Auditing account disabling actions will support account management procedures. When device management accounts are disabled, user or service accessibility may be affected. Auditing also ensures authorized active accounts remain enabled and available for use when required.

ℹ️ Check
Review the switch configuration to determine if it automatically audits account disabling. The configuration should look similar to the example below: archive log config logging enable Note: Configuration changes can be viewed using the show archive log config all command. If account disabling is not automatically audited, this is a finding.

✔️ Fix
Configure the switch to log account disabling using the following commands: SW4(config)#archive SW4(config-archive)#log config SW4(config-archive-log-cfg)#logging enable SW4(config-archive-log-cfg)#end