The Cisco perimeter router must be configured to have Cisco Discovery Protocol (CDP) disabled on all external interfaces.

Severity	Group ID	Group Title	Version	Rule ID	Date	STIG Version
low	V-216585	SRG-NET-000364-RTR-000111	CISC-RT-000370	SV-216585r856190_rule	2024-11-25	3

Description
CDP is a Cisco proprietary neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. CDP is media- and protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing CDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.

Description

CDP is a Cisco proprietary neighbor discovery protocol used to advertise device capabilities, configuration information, and device identity. CDP is media- and protocol-independent as it runs over layer 2; therefore, two network nodes that support different layer 3 protocols can still learn about each other. Allowing CDP messages to reach external network nodes provides an attacker a method to obtain information of the network infrastructure that can be useful to plan an attack.

ℹ️ Check
This requirement is not applicable for the DODIN Backbone. Step 1: Verify CDP is not enabled globally via the command no cdp run By default CDP is enabled globally; hence, the command cdp run will not be shown in the configuration. If CDP is enabled, proceed to step 2. Step 2: Verify CDP is not enabled on any external interface as shown in the example below. interface GigabitEthernet0/1 ip address x.1.23.2 255.255.255.252 no cdp enable Note: By default CDP is enabled on all interfaces if CDP is enabled globally. If CDP is enabled on any external interface, this is a finding.

ℹ️ Check

This requirement is not applicable for the DODIN Backbone. Step 1: Verify CDP is not enabled globally via the command no cdp run By default CDP is enabled globally; hence, the command cdp run will not be shown in the configuration. If CDP is enabled, proceed to step 2. Step 2: Verify CDP is not enabled on any external interface as shown in the example below. interface GigabitEthernet0/1 ip address x.1.23.2 255.255.255.252 no cdp enable Note: By default CDP is enabled on all interfaces if CDP is enabled globally. If CDP is enabled on any external interface, this is a finding.

✔️ Fix
This requirement is not applicable for the DODIN Backbone. Disable CDP on all external interfaces via no cdp enable command or disable CDP globally via no cdp run command.