The Cisco multicast Rendezvous Point (RP) router must be configured to filter Protocol Independent Multicast (PIM) Join messages received from the Designated Router (DR) for any undesirable multicast groups.

Severity
Group ID
Group Title
Version
Rule ID
Date
STIG Version
lowV-216812SRG-NET-000019-RTR-000014CISC-RT-000840SV-216812r531087_rule2024-08-223
Description
Real-time multicast traffic can entail multiple large flows of data. An attacker can flood a network segment with multicast packets, over-using the available bandwidth and thereby creating a denial-of-service (DoS) condition. Hence, it is imperative that join messages are only accepted for authorized multicast groups.
ℹ️ Check
Verify that the RP router is configured to filter PIM join messages for any undesirable multicast groups. In the example below, groups from 239.8.0.0/16 are no allowed. ipv4 access-list FILTER_PIM_JOINS 10 deny ipv4 239.8.0.0 0.0.255.255 any 20 permit ipv4 any any … … … router pim address-family ipv4 allow-rp group-list FILTER_PIM_JOINS If the RP is not configured to filter join messages received from the DR for any undesirable multicast groups, this is a finding.
✔️ Fix
Configure the RP to filter PIM join messages for any undesirable multicast groups as shown in the example below. RP/0/0/CPU0:R2(config)#ipv4 access-list FILTER_PIM_JOINS RP/0/0/CPU0:R2(config-ipv4-acl)#deny 239.8.0.0 0.0.255.255 RP/0/0/CPU0:R2(config-ipv4-acl)#permit any RP/0/0/CPU0:R2(config-ipv4-acl)#exit RP/0/0/CPU0:R2(config)#router pim RP/0/0/CPU0:R2(config-pim)#address-family ipv4 RP/0/0/CPU0:R2(config-pim-default-ipv4)#allow-rp group-list FILTER_PIM_JOINS RP/0/0/CPU0:R2(config-pim-default-ipv4)#end